Secret Icer 5 bags: ice water resin extraction, in 4 grades
Trim and small buds are covered in trichomes that nearly always end up in the bin. The Secret Smoke Secret Icer 5 bags kit lets you recover them with the cleanest method there is: water, ice and 5 filter bags. No solvents, and far purer resin than dry sifting. With its 5 bags you split the resin into 4 different grades, from coarsest to finest.
What’s in the kit
- Yellow 190 µm bag: pre-filter that holds back plant matter and ice.
- Red 120 µm bag: catches the largest trichome heads, sometimes with a little plant matter.
- Green 70 µm bag: catches medium-sized mature heads, often the most prized fraction.
- Blue 45 µm bag: catches the small heads for a fine resin.
- Black 25 µm bag: the finest fraction; the amount depends on each strain’s trichome size.
- Tensioner to fit the bags to the bucket.
- Instruction manual with the step-by-step process.
How ice water extraction works
Ice-cold water makes trichomes hard and brittle. As you stir the material, they break away from the plant and stay suspended in the water. The bags do the rest: the 190 µm holds back leaves and debris, and the following bags catch the trichome heads by size while the water drains. The result is the resin known as ice-o-lator or bubble.
Step-by-step instructions
- Put the bags in a bucket, from finest to coarsest: 25 µm, 45 µm, 70 µm, 120 µm, 190 µm. Each one goes inside the previous one, label facing out. Fold the edges over the bucket and stretch them as smooth as possible, with no creases where resin could get trapped.
- Prepare the mix in another bucket: plant material (small buds and sugar leaves, with no stems that could damage the bags), ice and cold water, just enough to cover the plant.
- Stir well for a few minutes with a whisk or a whisk-type mixer, never a bladed one, so the trichomes come loose.
- Pour the mix into the bucket with the bags.
- Lift out the yellow 190 µm bag and drain it gently: it holds the plant matter and ice, which you can reuse for a second run.
- Lift out the other bags one by one and let the water drain. Gather the resin in the centre, carefully turn the bag inside out and collect it with a card or spoon, keeping each grade separate.
- Dry the resin somewhere cool, dark and ventilated, spread in a thin layer on baking paper.
Tips for a good result
- Use good material: big fan leaves hold little resin and dirty the extraction.
- Keep everything cold: more ice than water and pre-frozen material give a cleaner extraction.
- The right bucket: the bags measure about 25 cm across and 44 cm high, holding roughly 20 L. Choose a tall, narrow bucket so they stay taut; if the rim is a bit wide, clip them in place.
- Several runs: the first gives the cleanest resin; you can repeat the process with the same material.
- Dry it fully: the resin must be completely dry before storage to prevent mould.
- Cleaning: rinse the bags in cold water after each use and let them dry before storing. If the finest ones clog over time, clean them with alcohol.
Specifications
| Brand | Secret Smoke |
| Model | Secret Icer 5 |
| Type | Ice water resin extraction bags |
| Number of bags | 5 |
| Microns | 190 µm (yellow) · 120 µm (red) · 70 µm (green) · 45 µm (blue) · 25 µm (black) |
| Resin grades | 4 |
| Size of each bag | Approx. 25 cm diameter × 44 cm high |
| Capacity | Approx. 20 L |
| Included | Instruction manual and tensioner |
How many bags do you need?
With 2 bags you get a single grade of resin, ideal for starting out. With 3 you separate two grades, and with 5 you reach four grades to fine-tune every extraction.
Want more or fewer grades? See also the Secret Icer 2 bags and the Secret Icer 3 bags.
If you’d rather have a quick method with no water, see our dry resin extraction category. More bags and accessories in ice resin extraction, and to compact the dried resin, our hash presses.
FAQ
In which order do the bags go?
From finest to coarsest: first the 25 µm, which stays on the outside, and last, inside all the others, the yellow 190 µm, which holds back plant matter and ice.
What size bucket do I need?
The bags measure about 25 cm across and 44 cm high. A tall, narrow bucket is ideal so they stay taut; if it’s a little wide, clip them to the rim.
Do I need a mixer?
It isn’t essential: a whisk will do. If you use a mixer, make it a whisk-type one, never bladed, so you don’t shred the plant or damage the bags.
How long does the resin take to dry?
It depends on the amount and conditions. Spread thin somewhere cool, dark and ventilated, it usually needs several days.
Can it be used dry?
Yes. As well as ice water extraction, the bags can be used to dry sift well-dried, cold material.
Free shipping across Europe on orders over 100 €. Orders are packed within 48 hours and shipped in discreet, unbranded packaging.
Product intended for extracting resin from plant material from your own garden. Sale to adults over 18 only. Please respect the laws in force in your country.


Reviews
There are no reviews yet.